bcf easi-scan - Page 10

10
1.4.1 BUGs control
The first 2 options in the Setup Sub-Menu allow the user to adjust the brightness and contrast of
BCFBUGs headmounted display.
To adjust the settings, select either ‘Contrast’ or ‘Brightness’, the word ‘Adjust’ will appear alongside
the selected option. Use the Up and Down buttons to adjust the settings, press the
Select button
to exit adjustment mode.
1.4.2 Low battery warning
When the external battery is nearing the end of its useful capacity, the on-screen indicator will start to blink.
In addition, by switching the ‘Low Batt Buzzer’ option to on, the scanner will give an audible indication.
1.4.3 Grid & graticule display
The Easi-Scan Micro-Convex allows the operator to display grid and/or graticule lines on the image.
The following options are available:
Off No grid or scale markings displayed
Grid 1⁄2 cm A 1⁄2 cm grid is displayed
Grid 1 cm A 1 cm grid is displayed
Scale Scale markings (1/5 cm on Detail mode, 1/2 cm on other modes)
are displayed down each side of the image
Grid & scale A 1 cm grid, and scale markings are displayed
1.4.4 Video link channel (remote monitor option)
The Easi-Scan Micro-Convex can transmit to an optional wireless monitor. To reduce interference and
allow the use of multiple Easi-Scans, the scanner can be set to transmit on one of four channels.
Press the Select button
to bring up the RF Channel Sub-Menu and use the Up and Down
buttons to select the required channel.
1.4.5 Bluetooth enable
The Easi-Scan Micro-Convex can be controlled via Bluetooth (See Appendix A).
This sub-menu allows the Bluetooth module to be switched On or Off.
The Bluetooth control functions are also available through an Android app called “Easi-Scan
Bluetooth” available from the Android app store.