9
Caution: If you rely on a viewing device plugged into the scanner display connector, altering this
setting will interrupt viewing, making it difficult to revert to correct setting. It is recommended
you do not alter this setting unless you have a Wireless monitor which will continue to display
regardless of changes to the Output selection setting.
The Output Sub-Menu can be accessed by Selecting ‘Output’ from the Main Menu.
Use the Select button
to choose from the following output options;
Wrist display Selecting this option feeds a digital video signal out of the front panel, this option
is used with the BCF wrist display accessory
Goggles Selecting this option feeds a standard greyscale NTSC video signal out of the
front panel, this option is used for BCF BUGs or other goggles, or if using a video
lead accessory (e.g. for video printer)
USB Selecting this option allows the user to connect the scanner to a computer via
the USB adapter accessory. This mode is used to copy stored images from the
scanner. See WARNING and instructions in Appendix B)
Note: If there is no image on your connected viewing device, and you do not have a Wireless
monitor to facilitate menu navigation to select the correct video output signal, the scanner
output can be switched by pressing and holding the button combinations (below) while
switching the scanner on.
For goggles Press and hold and simultaneously while switching on
For wrist display Press and hold
and simultaneously while switching on
1.3.10 Selection of languages for the menu
The menu on Easi-Scan is available in English, German, French, Italian, Spanish, Polish, Portuguese
and Russian.
To choose the language:
Press the button
to switch the Main Menu on. Use the Up and Down buttons to select ‘Setup’.
Then use Up
and Down buttons to select Language. Then choose your language from the menu.
If you have chosen the wrong language accidently, disconnecting the battery will switch the scanner
back to the previous language. The language setting will only be saved if you switch off your scanner
using the Power button
.
1.4 Scanner setup
Preferences such as image orientation and graticule grid display may be altered and stored as default
at start-up. The Setup Sub-Menu can be accessed by Selecting ‘Setup’ from the Main Menu.
To Next Page
Loading...