bcf easi-scan - Bluetooth Control Details; Data Entry and System Reset

11
Bluetooth control
The Easi-Scan Micro-Convex allows control of certain scanner functions via Bluetooth, all functions
are controlled in the same manner. A Bluetooth device (phone, PDA, PC etc) sends an address entry
(vcard) where the Name takes one of the following forms:
M Sending this name will switch to the next mode
M D Sending this name will switch to Detail mode
M F Sending this name will switch to Foetal Sexing mode
M O Sending this name will switch to Ovary/Early mode
M L Sending this name will switch to Late mode
C (followed by Cattle Identification) – Sending this name followed by a space and
the Cattle ID number will change the cattle ID on the scanner
P (Practice Name) – Sending this name followed by a space and the Practice name
will change the practice name on the scanner
F Sending this name will Freeze/Unfreeze the scanner
Initial ‘pairing’ between your Bluetooth device and your Easi-Scan Micro-Convex will require you to
enter a ‘Passkey’. Refer to the manual for your Bluetooth device for details on pairing with another
device.
The passkey for Easi-Scan Micro-Convex is ’0000’ (four zeros).
1.4.6 Practice data entry
The Easi-Scan Micro-Convex allows the operator to enter a practice name which will be overlaid on
any image that is stored. Selecting ‘Practice Data’ from the Setup Sub-Menu brings up the Practice
Data Entry Menu. The operator can use the Up
and Down buttons to select the digit to be
changed, pressing ‘Select’ highlights the digsit and its value can be changed by using the Up
and
Down
buttons, pressing ‘Select’ again returns to the digit selection mode. To exit this sub-menu,
it is necessary to either wait for the menu to blank or press and hold the Select button
until the
scanner beeps twice and the menu exits.
1.4.7 Factory reset
Selecting ‘Reset’ from this sub-menu will reset all settings to factory defaults, stored images are
not affected.
1.4.8 Menu timer
Selecting ‘Short’ from this sub-menu will set the time the menu is displayed to about one second.
Selecting ‘Long’ from this sub-menu will set the time the menu is displayed to about four seconds.
1.5 Smart Display
The Easi-Scan Micro-Convex may be used with the Smart Display accessory .