BCP SKY6604 - Additional Features; Troubleshooting

ADDITIONAL FEATURES
HOW TO USE TOUCH FEATURE
This keyboard is enabled with a Touch Sensitivity
feature that will allow the note being played to
correspond to the velocity of the key being
pressed. Volume depends on how hard the key is
pressed.
The Touch feature is on by default. To turn o
touch feature, press “touch”
HOW TO USE PERCUSSION FUNCTIONS
Press the “Drum” button to turn the digital piano
into a drum keyboard. Press again to turn
function o.
HOW TO USE DUAL TONES
The Dual Tone feature allows you to play two
tones simultaneously.
1. First enter the tone mode and choose a tone
2. Press the “dual” button to enter the second
tone
3. Use the “+” or “-“ keys to select a second tone
HOW TO SPLIT THE KEYBOARD
Using this feature will split the keyboard into two
dierent tones.
1. Enter the tone mode and choose a tone
2. Press the “Split” key to enter split mode
3. Use the “+” or “-“ keys to select a second tone
4. Press “split” again to end mode
METRONOME
Press the metronome button to turn on and select
“+” or “-“ to change the tempo.
RECORDING
1. Press the “record” button to enter recording
mode
2. The maximum number of recordings is 250
notes
3. Each time the record button is pressed, the
previous recording overwritten by the new
recording
PLAY
Press the “play” button to playback recordings
MP3 FUNCTION
1. Directly enter mp3 mode after connecting usb
flash disk into drive on front panel
2. Press “start/stop” buttons to start and pause
playback
3. Press “+” or “-“ to select songs on drive
TROUBLE SHOOTING
When the Power is turned on,
there is noise
PROBLEM SOLUTION
There is noise when using a mobile phone
When the keyboard is played, there is
no sound
The chosen Tone has low volume
A sound anomaly in timbre or rhythm
The accompaniment is not
pronounced properly
This is normal, and means the current is
entering the machine
Using a mobile phone in the vicinity of the
keyboard produces radiation
To avoid this, turn o mobile phone or stay
away from instrument
Verify that the headphone jack is
not plugged in
Verify that master volume is at desired
level and dual tone is not engaged
AC voltage is low
Make sure the accompaniment volume is set to
the appropriate level
Tone is distorted
Volume is too high; it should be less than
¾ position
8 |