EasyManua.ls Logo

BE BE3500IP - Carburetor Adjustment; Engine Oil Replacement

BE BE3500IP
80 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
28
7.2 Carburetor adjustment
The carburetor is a vital part of the engine. Adjusting should be left to
our company authorized dealer with the professional knowledge and
equipment to do so properly.
7.3 Engine oil replacement
WARNING
Avoid draining the engine oil immediately after stopping the
engine. The oil is hot and should be handled with care to avoid
burns.
NOTICE
• Do not tilt the generator when adding engine oil. This could result

Recommended engine oil: SAE 10W30
Recommended engine oil grade: API Service SE type or higher
Engine oil quantity: 0.5L
NOTICE
• Be sure no foreign material enters the crankcase.
MAINTENANCE
Avoid draining the engine oil immediately after stopping the engine. The
oil is hot and should be handled with care to avoid burns.
1. Place the generator on a level surface and warm up the engine for
several minutes. Stop the engine by turning the switch to “OFF”.
2. Remove the screws on the cover and then remove the cover.
3. Place an oil pan under the engine.

5. Reinstall the oil drain bolt.

7. Wipe the cover clean, and wipe up any spilled oil.

9. Install the cover and tighten the screws.

Related product manuals