BE P1815EN - Operating Instructions; Using the High;Low Pressure Nozzle

10 11
IMPORTANT: When applying detergent
using low pressure spray, the variable
spray head must be set for the “Pencil
Stream”. This is when the metal blades
in front of the nozzle are wide open so
the detergent spray is not constricted.
2
2
IN position
IN position
High Pressure Setting
Fan Spray Pencil Stream
1
1
2
OUT position
OUT position
LOW Pressure Setting
Pencil Stream
Using High/Low Nozzle
• High pressure spray is used for
cleaning and low pressure spray
activates the detergent function.
• The adjustable spray nozzle had has
two (2) positions:
– IN position for high pressure spray.
Twist the nozzle counterclockwise until
it stops and gap is closed.
– OUT position for low pressure spray for
detergent function. Twist the nozzle
clockwise until it stops and gap is open.
• When using the high pressure setting,
twist the nozzle head clockwise or
counterclockwise to achieve the stream
desired.
• When using the low pressure setting
twist the nozzle head clockwise to
open the fan blades all the way.
OPERATING INSTRUCTIONS
Attach garden hose to the garden
hose adapter (F).
Note: Flush out garden hose before
connecting to garden hose adapter.
You have now completed assembly
and are ready to begin using your
electric power washer. Read and
observe all safety instructions.
• Turn on water supply at the
faucet to completely open
• Make sure the “ON/OFF” switch
is in the “OFF” position. The
power switch has international
symbols for ‘on’ and ‘o’: On (|)
O (O).
• Unwind the power cord
completely and plug the GFCI
into a grounded 120 volt outlet.
• Release safety push trigger lock
up and back into trigger. While
pointing the spray gun in a safe
direction, squeeze the trigger
on the spray gun until there is a
steady stream of water, letting
the water and air out of the
hose. Push trigger lock back
down to lock back into place.
OFF/0
ON/I
OFF/0
ON/I
• Turn the power switch to the “ON” (|)
position. The unit will turn on for 1 - 2
seconds and shut o. This is a normal
function of the auto start feature.
Squeeze the spray gun trigger to
begin pressure washing.
• Begin power washing by squeezing
the trigger on the spray gun all the
way into the handle.
• Release the spray gun trigger to stop
the power washer
• Allow the motor to come to a
complete stop before squeezing the
trigger again.
• Squeezing rapidly will cause the auto
start feature to miss an on/o cycle
that may prevent it from turning on
while squeezing trigger after rapid
squeezing. Use slow deliberate
trigger pulls to avoid such symptoms.
• Always spray a small area first to
avoid chance of damaging surface.