Beaba MILKEO - Initial Operation and Configuration; Powering On and First Use; Setting Up for First Bottle

3. Switching on the product
- Pour the water into the water reservoir
2
- Pour the powder into the powder reservoir
1
- Plug in the product
- Press the power button.
3
pressing the button. At the end of the cycle put on the powder reservoir.
- If you do not use the product for a period of 3 minutes, the control panel locks automatically. To unlock it, press the lock/
unlock button for 1,5 seconds
- You can lock the control panel manually by pressing the lock/unlock button for 1,5 seconds
- Press once on the settings button
Set the desired temperature with the + and – buttons
- Press again on
- Press again on
about the quantity of power, follow the indications in the next section.
- Press the settings button
- Place the bottle on the bottle stand
4
selecting one of the two heights according to the size of the bottle
- Press the bottle preparation button to prepare a bottle.
The settings will be saved for the following bottles. Repeat the operation to change the settings. If you modify the quantity
13