Need help?Do you have a question about the Beamz MHL74 and is the answer not in the manual?
Check contents upon arrival, retain original packing for transport or returns.
Verify voltage, connect to earthed circuit, check outlet voltage.
Multi-colors, strobe, dimming, built-in mic, DMX-512, auto/master/slave sync, 7x10W LED.
Details DMX channel modes and functions for 8 and 13 channel configurations.
Step-by-step guide to replacing the fuse in the unit.
Connect fixtures serially for controller or master/slave sync. Details cabling and conversion.
Procedure for setting up master/slave synchronization between fixtures.
Guidance on mounting positions and ventilation requirements.
Use MODE/ESC, UP, DOWN, ENTER buttons to navigate menus and select options.
Set maximum pan angles (180/360/540) and tilt angles (90/180 degrees).
Configure pan/tilt/display reversal, select Auto Run speeds, and Sound Activated mode.
Slave units sync with master unit in Auto Run or Sound Activated Modes.
Reset unit to factory defaults or reboot after configuration changes.
Select 8 or 13 channel modes. Set DMX addresses from d001 to d512.
How to select from the 16 preset color options.
Detailed list of functions and value ranges for each DMX channel in 8 and 13 channel modes.
Check contents upon arrival, retain original packing for transport or returns.
Verify voltage, connect to earthed circuit, check outlet voltage.
Multi-colors, strobe, dimming, built-in mic, DMX-512, auto/master/slave sync, 7x10W LED.
Details DMX channel modes and functions for 8 and 13 channel configurations.
Step-by-step guide to replacing the fuse in the unit.
Connect fixtures serially for controller or master/slave sync. Details cabling and conversion.
Procedure for setting up master/slave synchronization between fixtures.
Guidance on mounting positions and ventilation requirements.
Use MODE/ESC, UP, DOWN, ENTER buttons to navigate menus and select options.
Set maximum pan angles (180/360/540) and tilt angles (90/180 degrees).
Configure pan/tilt/display reversal, select Auto Run speeds, and Sound Activated mode.
Slave units sync with master unit in Auto Run or Sound Activated Modes.
Reset unit to factory defaults or reboot after configuration changes.
Select 8 or 13 channel modes. Set DMX addresses from d001 to d512.
How to select from the 16 preset color options.
Detailed list of functions and value ranges for each DMX channel in 8 and 13 channel modes.
General| Model | MHL74 |
|---|---|
| Category | Lighting Equipment |
| Type | Moving Head Light |
| Light Source | LED |
| LED Quantity | 7 |
| LED Colours | RGBW |
| Pan Range | 540° |
| Tilt Range | 270° |
| Power Supply | AC |
| Control | DMX, Auto |
| Effects | Strobe, Dimmer |
| Voltage | 100-240V |
To Next Page
