When battery power is low, the power LED will flash indicating that the
batteries must be charged.
To charge the batteries:
• Plug the mains plug of the charger into a 100-240VAC (50/60Hz) power
supply.
• The red LED on the charger will flash.
• Plug the charge plug into the charge port on the laser.
• The red LED will light solidly while the battery is charging.
• When charging is complete, the red LED on the charger will flash again.
• On average, a full charge will take approximately 7 hours.
Note:
• The instrument can still be used
while it is charging.
• Brand new rechargeable batteries or
those that have not been used for a long
time may need to be charged and
discharged several times before they
attain maximum capacity.
— 13 —
Charging Port
Charger
To Next Page