BEARWARE 302688 - Alarm Settings

26 English
8.2 Alarm seng
The weather staon can store up to 2 alarm sengs, which can be turned on and
o separately at the side using a ip switch. By pressing the "MODE" buon you
can view the congured alarm mes. The alarm mes are shown at the place
where the date is displayed normally.
Seng the alarm
Press and hold the "MEM" buon for about 3 seconds to access the alarm
sengs. The alarm me is now displayed instead of the date. You can make the
desired sengs using the "+" and "-" buons. Then press the "MEM" buon
again to save the alarm seng. You can congure these sengs using Alarm 1
(A1) and Alarm 2 (A2). Conrm your entry using the "MEM" buon.
Turning the alarm on and o
Aer seng the alarm successfully, you can turn it on or o using the ip switch
located on the side.
Mung the alarm
When the alarm is acvated at the congured me, the backlight also turns on
automacally. The alarm is acve for 2 minutes before it turns o automacally. If
the alarm does not turn o within these 2 minutes, then it repeats automacally
aer 24 hours.
Press the "SNOOZE/LIGHT" buon to cancel the alarm. If a snooze symbol is
shown on the display, this means that the snooze funcon is acvated and the
alarm will go o again in 5 minutes.
Place the ip switch on the side of the device to the "OFF" posion to turn o the
alarm.