BEARWARE 302688 - Basic Settings

24 English
Indoor temperature display:
The indoor temperature is measured by the base
staon and is shown with an accuracy of one
tenth of a degree. The congured temperature
unit is displayed to the right of the measured
value. The temperature unit can be changed
between ° C and ° F. This has to be congured in
the basic sengs.
The measured value should not be below the minimum value (-9.9°C / 14°F) or
above the maximum value (50°C / 122°F).
Outdoor temperature display:
The outdoor temperature is measured by the
outdoor sensor and shown with an accuracy of
one tenth of a degree. The congured tempera-
ture unit is displayed to the right of the measu-
red value. The temperature unit can be changed
between ° C and ° F. This has to be congured in
the basic sengs.
The measured value should not be below the minimum value (-40°C / -40°F) or
above the maximum value (70°C / 158°F).
8. Basic sengs:
Note: Firmly touching the top of the housing will switch on the backlight.
Aer the "SNOOZE/SLEEP" buon is released, it switches o again aer 5
seconds. Please note that the base staon does not respond to 2 buons at
the same me. It is therefore advisable to press only one buon.
Press and hold the "MODE" buon for about 3 seconds to congure the basic
sengs. With the "+" and "-" buons you can change the values accordingly.