10
8.3 Preparations Before Cleaning
Before entering the water, it is crucial to place the robot on a level ground and
to wait for about 5s for it to calibrate. By following these steps, you ensure
maximize the effectiveness of the robot's cleaning path.
After placing the robot in the water, it will start cleaning automatically ( ).
Set the cleaning mode, and the selected mode button will show solid white ( ).
Before entering the water, place the robot on a level surface and wait for about
5s for it to calibrate ( ).
Before cleaning, make sure the robot is turned on and has enough power. The panel
indicator on the robot should be solid green when the robot is fully charged ( ).
(If you have connected the robot to the APP, you can also check the power level
within the APP).
3
1
2
4
1 2
3
4
5s
Before cleaning, please make sure there are no foreign objects such as towels or toys
in the pool.
Tips
When the robot enters the water, the Wi-Fi signal weakens and it disconnects from
the phone. Once the robot exits the water, including when it is on the water's surface,
the Wi-Fi signal will be restored. The App will automatically reconnect and synchro-
nize the relevant cleaning data.
Avoid animals and people from entering the pool during cleaning.
For optimal cleaning results, it’s recommended to operate the robot separately from
the circulation pump.
EN
To Next Page
