5 Robot buttons
1 2 3
6
Hotspot Configuration
Press and hold both the "Quick Mode" ( ) and "Power" ( ) buttons simultaneously
for about 3s to trigger the hotspot configuration.
1
2
Press the corresponding mode button to switch.
Quick mode ( ): Clean the floor once;
Standard mode ( ): Clean once in the order of floor, wall and waterline.
Mode Button
1
3
Power Button ( )
Short press to turn the robot on, and press and hold for about 3s to turn it off.
2
Factory Reset
Press and hold the "Quick mode" ( ), "Power" ( ) and "Standard Mode" ( ) buttons
simultaneously for about 10s to restore the factory settings.
1
3
2
EN
To Next Page
Loading...
