10
N.B. When it is no longer necessary to monitor the baby’s breathing
as he grows older, the movement sensor mat is required to unpair
from BU to avoid false alarm. To achieve this peform pairing process
again between PU & BU by repeating above steps 1-8, but leave out
steps 11-13.
10. The pairing between BU and movement sensor mat should be performed
after the successful pairing between BU and PU or otherwise the system
will not operate properly.
11. Set the BU into pairing mode by repeating step 3 above.
12. While pressing down the alarm hold button 21, switch on the movement
sensor mat by turning the knob 20 clockwise, now release hold button 21.
Press the feeder timer button 4 , the transmit indicator 12 shows steady
on and two beep sound will be heard in the BU, indicating the pairing is
successful.
In case you have two movement sensor mats to be paired to two BU,
Please pair each one in turn with the other BU being switched off.
13. Switch off both the BU and sensor mat, then switch on again for normal
operation, probably you will hear the abnormal breathing alarm in PU after
20 sec in case nothing is placed on the movement sensor mat. Slight tap
the mat few times and the alarm will stop, this shows the system is working
properly.
To Next Page
Loading...
