14
N.B. In case there are two BUs operating in the system, besure each BU
and its corresponding sensor mat are far away from each other and
placed in separate rooms to avoid interfering each other and
creating false alarm.
BSM-1
BSM-2
3. For environment with continuous vibration from the floor, the sensor mat may
has false detection and delay or prevent the alarm from sounding. Under
such circumstance, move the crib to the corner of the room or near a solid
supporting wall. Moreover, keep the crib away from strong draft and air
current.
4. Besure the BU and sensor mat is within the same room or apart from each
other not more than a distance of 10m, otherwise they may lost connection
with each other and breathing movement of baby cannot be monitored.
5. When parents need to take baby out from crib for feeding or other purpose,
to avoid breathing alert alarm, short press the alarm hold button 21 . This
button can be pressed before or after taking out the baby, but such action
must be performed within 20 sec, or otherwise the alarm would still sound.
To stop alarm in PU, short press hold button 21 again.
Upon placing back the baby into crib, the sensor mat will automatically
resume monitoring the baby movement after 20 seconds.
6. When the baby’s movement increases as he grows older, he may move
away from the sensor mat and cause false alarm. Additional movement
sensor mat can be connected to increase the coverage.
To Next Page
Loading...
