- The front LEDs display incorrectly
- Still cannot access to the router
management interface after pressing the
RESET button.
- Software / Firmware upgrade failure
1. Power on the router, once the Power LED lit red,
please press this reset button using the end of paper
clip or another small pointed object immediately.
2. The router’s emergency-reflash web interface will
then be accessible via http://192.168.1.1 where you
can upload a firmware image to restore the router to
a functional state, please note that the router will
only respond with its web interface at this address
(192.168.1.1) and will not respond to ping request
from your PC or other telnet operations.
To Next Page
Loading...
