DV14307.03 Issue 06 February 2021 Transceivers 6200 Series 141
• The transceiver has detected an internal failure during start up.
• Depending on failure cause, the device is operable with decreased
performance or not operable at all.
Possible cause:
• Outside specified environmental conditions.
• HW or SW failure inside the transceiver.
• The transceiver has no communication with the controller.
• Depending on failure cause, the device is operable with decreased
performance or not operable at all.
Possible cause:
• Problem with the interwiring.
Contact maintenance shop for assistance, if you cannot find the failure.
3.16 Contact Data
In case of additional questions contact your local Becker Avionics dealer or forward your request direct
to Becker Avionics "Customer Service".
In the event of damage or a defect, the entire device must be returned for repair. The repair must be
done by trained Becker Avionics personnel.
For relevant department and addresses, please see contact info page 2.
Any change by the user excludes any liability on our part (excluding the work described in this
manual).
To Next Page
Loading...
Need help?
General
