Becker DTM - Audio Settings Adjustment

76
*HQHUDO2SHUDWLRQ
$GMXVWLQJWKH)DGHU
Press the button. Then press the multifunction button
.
Adjust the fader setting to the desired level by pressing the
right rotary control .
$GMXVWLQJWKH%DODQFH
Press the button. Then press the multifunction button
.
Adjust the balance to the desired level by pressing the right
rotary control .
/LQHDU6HWWLQJ
Press the button briefly.
Press the multifunction button briefly -
!65, -3(;
will be displayed. By pressing the multifunction button
again, the tone adjustments for the current signal source (i.e.
FM) will be reset to mid-level.
/RXGQHVV2Q2II
Press the button then press the multifunction button
.
Using the multifunction button either Loudness On
(
) or Loudness Off () can be selected.
In the MW, LW and SW wavebands, Loudness is switched
off.
6281'
(+
!"/ V
(:!9) (+ (3 3; <) +5
6281'
(3
)+ " V
(:!9) (+ (3 3; <) +5
6281'
,+"#)1?
(:!9) (+ (3 3; <) +5
3;
3;
6281'
+5
,2!+"00
(:!9) (+ (3 3; <) +5
+5