Beckhoff Economy CP72 Series - USB-Interface (Optional); Pre-Assembled USB-Cables; Fitting the USB-Cable with IP65 Connector

Installation Instructions
CP72xx 21
USB-interface (optional)
Order option C9900-E187
Optionally a USB 2.0 interface with 4-pole-connector (M12-female
connector IP65) in the connection area is available with order option
C9900-E187:
Order number
Denomination
C9900-E187
IP65 connector M12 in the wiring area of a CP72xx for one
USB 2.0 Port
Pin assignment for
connecting the USB-
interface (optional)
Pin assignment,
view connector-sided
Female connector 4-pole Escha 8029477
Pin
Signal
Color
1
VCC
Red
2
D -
White
3
GND
Black
4
D +
Green
Pre-assembled USB-cables
Pre-assembled USB-cables
For easy installation of the USB-interface in the wiring area there are pre-
assembled USB-cables of different length and with IP65-connectors
available (see table).
Note
Usage of the Cables
These USB-cables can not be used for connecting the following options:
• C9900-E190 (USB-A in the wiring area of a CP72xx for one USB 2.0
Port)
• C9900-E169 (2-port USB socket inside the Control Panel back plane)
Order number
Denomination
C9900-K291
USB cable for CP72xx, length 3 m, assembled,
M12 connector IP65, screw type, 4 pin, second end USB-B
connector
C9900-K292
USB cable for CP72xx, length 5 m, assembled,
M12 connector IP65, screw type, 4 pin, second end USB-B
connector
Fitting the USB-cable with IP65 connector
Required connector
For connecting the USB-interface the following connector is needed cable-
sided:
• Connector 4-pole round shield Binder 99142981404
For further information see http://www.binder-connector.de/.