Wt and Bal/Equip List
Section 6
Model G58
6-15
LOADING COMPUTING PROCEDURE
Loadings may be prepared accumulating
weights and moments/100 only and using
the Moment Limits vs. Weight Table for
Step 10. compliance. Or, by also including
the calculated arms as indicated and using
the Weight and Balance Diagram for Step
10. compliance. For each step that indi-
cates the Arm to be calculated, divide the
total moment/100 by the total weight and
multiply the result by 100.
1. Record the most current Basic Empty Weight, Arm
(optional) and Moment on line 1. The moment must be
divided by 100 to correspond to the Useful Load Weights
and Moments Tables.
2. Record the weight, arm (optional) and corresponding
moment/100 from the appropriate Useful Load - Pay-
load, Weights and Moments Table, for each payload
item on lines 2. through 9.
3. Total the weight column and moment/100 column to
determine the Zero Fuel Weight on line 10. Calculate
the arm.
4. Record the weight and corresponding moment/100 for
the total fuel loaded on line 11. Add the fuel weight and
moment/100 to the Zero Fuel Weight values to deter-
mine the Ramp Weight on Line 12. Calculate the arm.
5. Record the weight and corresponding moment/100 for
the fuel to be used for start, taxi and take-off on Line 13.
Subtract the fuel weight and moment/100 from the Ramp
Weight values to determine the Take-off Weight on Line
14. Calculate the arm.
December, 2009
sec06.fm Page 15 Monday, December 14, 2009 3:58 PM
To Next Page