EasyManua.ls Logo

Beem CM-501E - Electrical and Injury Risks

Beem CM-501E
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
19 EN
In the interest of your own safety, inspect the device and the connect-
ing cable for damage each time before you use it. Use the device only
if it is in working order.
Do not make any modi cations to the device. Do not replace the
connecting cable yourself. If the device or the connecting cable of
the device is damaged, it must be replaced by the manufacturer,
customer service department or a specialist workshop in order to
avoid any hazards.
It is essential to follow the instructions in the "Cleaning and Care”
chapter.
DANGER – Risk of Electric Shock
Use the device only in closed rooms.
Do not use the device in rooms with high humidity.
Should the device fall into water, switch off the power supply immediately. Do not attempt to pull
it out of the water while it is still connected to the mains power!
Never touch the device and the connecting cable with wet hands when these components are
connected to the mains power.
Make sure that the steam which emerges is not aimed directly at electrical devices and equip-
ment containing electrical components.
WARNING – Danger of Injury
Danger of suffocation! Keep children and animals away from the packaging material.
Keep items of clothing such as scarves, shawls, jewellery, ties and long hair away from the
coffee bean compartment and the grinder shaft.
Do not reach into the coffee bean compartment and the grinder shaft and do not insert any
objects when the device is in operation!
Danger of scalding from heat, hot steam or condensation!
Avoid coming into contact with the rising steam. Do not open the water tank lid during
the brewing process.
Be careful when removing the lter insert and the permanent lter after operating the
device. There may still be hot water remaining in the lter insert and in the permanent
lter! Always allow all parts to cool down rst before they are removed / cleaned.
Never pour water into the water tank when the device is switched on or during the
brewing process. Allow the device to cool down before lling it again.
08769_DE-EN-FR-ES-IT_A5_V3.indb 1908769_DE-EN-FR-ES-IT_A5_V3.indb 19 13.01.2020 13:57:1713.01.2020 13:57:17

Table of Contents

Related product manuals