Why won't my Beem CM-501E start at the set time?
If your Beem Coffee Maker does not start the brewing process at the set timer time, it is because the power supply has been cut in between times. As soon as the power supply is cut, all settings (time, timer) are cancelled.
Why does my Beem CM-501E Coffee Maker coffee not taste good?
If the coffee from your Beem Coffee Maker doesn't taste very good, several factors could be at play. First, ensure you're using enough coffee powder in the permanent filter, referring to the “Preparation” chapter for guidance. Second, the device may need a thorough cleaning, as detailed in the "Cleaning and Care" chapter. Third, the coffee/water mixture might not be ideal, so adjust it to suit your taste. Finally, poor water quality can affect the taste, so check your water quality and filter if necessary.
Why is my Beem CM-501E producing so much steam?
If your Beem Coffee Maker is producing a large amount of steam during brewing, it's likely due to the device being furred up. Descale the device as described in the "Cleaning and Care" chapter, specifically the “Descaling” section.
What to do if my Beem Coffee Maker runs coffee slowly?
If the coffee is running very slowly out of the coffee outlet of your Beem Coffee Maker, it could be due to a blockage in the coffee outlet. Try cleaning the coffee outlet. Alternatively, the device may be furred up, in which case you should descale it as described in the "Cleaning and Care" chapter under “Descaling”.
Why does my Beem CM-501E have an unpleasant smell?
If you detect an unpleasant smell during the use of your Beem Coffee Maker, it could be because the device is being used for the first time. A smell often develops when new devices are first used, but it should disappear after several uses. Alternatively, if the device has been descaled recently, rinse it out with clear water.
Why does my Beem CM-501E turn off mid-brew?
If your Beem Coffee Maker switches off during the brewing process, it's likely because there is no longer any water in the water tank. Refill the water tank, referring to the “Handling and Operation” chapter – “Filling the Water Tank” for instructions.
How to fix a Beem CM-501E with a blank display?
If nothing is shown on the display of your Beem Coffee Maker, first ensure that the mains plug is correctly inserted into the plug socket. If it is, try another plug socket to rule out a defective socket, and check the fuse of the mains connection to ensure there is mains voltage.
What to do if my Beem Coffee Maker is leaking water?
If water runs out of your Beem Coffee Maker, it is likely that there is too much water in the water tank. Avoid overfilling the water tank!
Why does my Beem Coffee Maker keep tripping the fuse?
If the fuse in the fuse box is triggered when using your Beem Coffee Maker, it might be because too many devices are connected to the same circuit. Try reducing the number of devices on the circuit.
Lists numbered components of the coffee machine for identification.
Details the buttons and display on the coffee machine's control panel.
Explains the meaning of various symbols used in the manual.
Defines signal words like DANGER, WARNING, CAUTION, NOTICE for hazard communication.
Specifies the proper and improper uses of the coffee machine.
Provides critical warnings, including advice on hot surfaces.
Details risks of electric shock, injury, suffocation, and entanglement.
Addresses fire hazards and risks of damage to the device and property.
Guides on initial placement, cleaning, and performing a trial run.
Explains display lighting and how to set the clock time.
Instructions for filling the water tank and inserting the filter holder.
Guide on adding coffee beans or powder to the permanent filter.
Steps for preparing the machine before brewing coffee.
Instructions for scheduling coffee brewing for a later time.
Steps to cancel or deactivate a scheduled brewing time.
Details on how to remove limescale deposits from the device.
General| Brand | Beem |
|---|---|
| Model | CM-501E |
| Category | Coffee Maker |
| Language | English |
To Next Page