EasyManua.ls Logo

Beem Pyramid A4 - Electrical Safety and Startup Procedures; Mains Cable and Earth Connection; Unpacking and Initial Preparation

Beem Pyramid A4
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
19
  
BEEM - Elements of Lifestyle
Ensure that the mains cable is
undamaged and is not laid over
sharp edges.
The mains cable must not be
pulled tightly, bent or come into
contact with hot surfaces.
Route the mains cable to prevent
risk of tripping.
Always unwind the mains lead
completely before connecting the
appliance to the plug socket.
The electrical safety of the appli-
ance is only assured when it is
connected to a properly installed
protective earth (PE) conductor
system. Connection to a mains
socket without PE conductor is
forbidden. If in doubt, the electri-
cal system must be checked by a
qualied electrician. The manufac-
turer assumes no liability for injury
or damage caused by a missing or
interrupted protective earth con-
ductor.


This indicates an imminent hazardous
situation, which could lead to severe
physical injury or death.
Follow these instructions to avoid
danger.

This indicates a possible hazardous
situation, which could lead to severe
physical injury or death.
Follow these instructions to avoid
danger.
ATTENTION
This indicates a potentially hazardous
situation, which could lead to minor
injuries or material damage.
Follow these instructions to avoid
danger.
NOTE
A note contains additional informa-
tion to simplify the use of the appli-
ance.
Startup

Remove the appliance, all accessory
parts and the user manual from the
box.
Remove all packaging materials and
protective foils from the product and
the accessories before using it for the
rst time.
NOTE
Never remove the rating plate or any
warning signs on the appliance..

Table of Contents

Related product manuals