Bego Eltropol 300 - Securing Objects for Polishing; Object Holder and Placement

30
85955 BA-en/11
English ⋅ Eltropol 300
en
Filling
1. Open the unit cover and position the magnetic
stirrer in the centre of the polishing bath - only
then can the stirrer function properly.
(Magnetic stirring only takes place during heat-
ing or polishing.)
2. Fill the polishing bath (the large bowl) with
approx. 2 litres of Wirolyt. The fill level must be
between the marks for maximum and mini-
mum.
NOTE
The drainage tube must be closed and securely
clamped!
NOTE
If the solution level is too low the unit electronics
malfunction!
WARNING
ATTENTION!
Wirolyt contains glycol and
sulphuric acid!
• Avoid contact with skin and eyes!
Risk of blinding!
• Wear safety glasses and safety
gloves!
Never add water!
• When mixed, acid and water pro-
duce an extreme chemical reaction.
Spitting acid is the consequence!
WARNING
Only transport or store the unit when
empty of Wirolyt!