120 Country Club Dr. Suite 22-L Incline Village, NV 89451 www.behmor .com
We suggest removing the lower one #3 (Photo F) then working up to #1 .
Now the bottom two screws #4 and #5. Start with #4 then #5. For better understanding of their position see
Photo I, # 4 and # 5
Carefully lay the panel flat so you can disengage the ribbon. If there is glue, it is easily dislodged/removed.
Disconnect the cable and wire.
Before doing anything further take special note of the pin (rests in a little notch) for the door (Photo H) and the
groove (yellow box) on the front panel’s side. When replacing the panel you will need to make sure the pin
slides into the groove properly. One item that helps insure this at the base of the panel you have a square
opening (Photo I) that fits over a plastic protrusion (Photo I-yellow square) on the base of the roaster.
Front Panel Replacement cont. 1600 Plus
Re-assembly
Now for reassembly which is doing everything in reverse as before, with a few hints/tips on making things
easier
First step would be to plug in the front panels two connectors.
Next replace the panel paying close attention to the pin and groove as noted previously (Photo H) and re-insert
screw #1. Once you replaced screw #1 look at the front of the roaster and check the bottom area by the pin, then
look upwards.
Is the gap similar in spacing as before? If, No- remove screw #1 and redo.
If yes, plug in the roaster and re-test the PCB as described in the roast manual:
To insure all functions are working properly press each button within each group in the following order: Press
all Weight buttons starting with ¼, ½, to 1 noting time in the display changes. Next, Profiles starting with P1
through P5, noting changes on the display. Next, Programs A through D, again noting display changes. Next
press, each (+ then -) Increments, Light, Cool, then lastly OFF. Start will be tested in the next step. ** Failure
to follow the order as indicated, will possibly lead to the false impression buttons C and D are not functioning.
These buttons are designed to not function in certain instances as discussed in Part V Paragraph 6 of the manual.
Now Test 2: unplug the roaster- while holding/ pressing Start- plug in your roaster then release Start. You
should see a series of numbers and hear components (fans) and lights come on- This should cycle fully twice-
Note 120 should appear early in the self-test Now----------------------Unplug the roaster !!!!!!!!.
Did everything test OK? If no ..
Recheck your two connections. Make sure everything is properly re-inserted. Plug in the roaster and retry. If
you are without a display, unplug the roaster and contact us immediately at tech@behmor.com Subject: front
panel replacement
To Next Page
Loading...
