Control 1.3 Swimming Pool Control Unit
General Note
5
Information about the Product Manufacturer
Manufacturer: Ingenieurbüro Bickele und Bühler GmbH
Address: St. Poeltenerstraße 70
70469 Stuttgart, Germany
If you have any questions about the product, please contact:
Phone: +49 (0)89 456917 – 0
Email: info@behncke.com
General Information about the Product
The product designated the “BEHNCKE Control 1.3” swimming pool control unit consists of the
components listed in Table 1:
Table 1: System components
The swimming pool control unit is used for reading and controlling the following products in swimming pool
areas:
- Filter pump
- Backwash valve
- Solar pump
- Solar valve
- Measurement and control system
- Fresh water valve
- Float switch
- Temperature sensor for outdoor areas
- Temperature sensor for swimming pool water
- Chemical level indicator
- Floor valve
- Rinse valve
- Roller shutter end positions
- Lowering valve
- Heating pump
- UV lamp
- Heating solenoid valve
The swimming pool control unit can be enhanced with the “Level control” (article number: 390 190 95) so
that the fill level of a splash water tank in an overflow pool can be read using hang-in electrodes.
To Next Page
Loading...