Declaration
Beholder is the licensed trade mark of TRD Beholder. Unauthorized use
of this trademark will be prosecuted. This product has patent granted in
most countries and copyrighted. Counterfeit products will not entitle to
any after service. Please check on web for authorized agents or contact
us at:
Website: http://www.teamrebeldesign.com/
Email: Beholder@TeamRebelDesign.com
Possible handheld angles and camera position
Adjust handheld positions and angles to achieve ideal results. There
are no limitation of angles and positions within the capable range of the
stabilizer
Note
1. DS1 was tune to precise setting before leaving the factory, for
whatever reasons, if fine tuning is necessary please refer to 4C (Gyro
Calibration Mode) to return to factory default setting.
2. Micro USB is for wired remote control and joystick calibration purpose,
Mini USB is for processor calibration by authorized personnel. Please
note that standard USB output is 5V with atleast 0.5A .
10
© 2015 Beholder All Rights Reserved
To Next Page
Loading...