Battery Holder
i) Check to make sure positive end of battery is facing upward in battery
holder.
ii) Check to make sure the spring contact in the battery holder is
connected to the negative end of the battery.
iii) Insert battery holder into the handle of the unit with positive end going
in first,
iv) Screw on battery cap and make sure the cap is securely locked.
Image 1
Image 2
Note i) USB power source which is lower than 1.5A will result in charging
failure and indicator light might fail as a result.
i i) It will take app.4- 5 hours to fully charge the battery, half the time
needed if using high speed charger.
Do not turn power on until the unit has a camera properly balanced
on it. Double check the battery compartment cap to ensure circuit
contact is in good order.
！
4
© 2015 Beholder All Rights Reserved
To Next Page
Loading...