Need help?Do you have a question about the Behringer 921 and is the answer not in the manual?
General| Brand | Behringer |
|---|---|
| Model | 921 |
| Category | Recording Equipment |
| Language | English |
Legendary Analog VCO Module for Eurorack.
Music Tribe accepts no liability for any loss which may be suffered by any person who relies on this document.
Details applicable warranty terms and conditions and additional information regarding Music Tribe's Limited Warranty.
Sets the oscillator frequency, influenced by COARSE RNG, SCALE, and RANGE switches.
Sets the general frequency range in octave steps, adjustable with the FREQUENCY knob.
Switch for ±6 octaves or ±12 semitones frequency control.
Controls oscillator frequency range: audio or lower frequency below audio threshold.
Sets default width for rectangular waveform, adjustable via CNTRL IN jacks.
Jacks for routing control voltage and modulation signals for rectangular waveform via 3.5mm TS connectors.
Sets the point at which the oscillator waveform resets.
Jacks for routing control signals for clamping point via 3.5mm TS connectors.
Selects waveform for auxiliary output signal (sine, triangular, sawtooth, square).
Adjusts the output level for the AUXILIARY OUTPUT jacks.
Route auxiliary waveform signals out of the module via 3.5mm TS connectors.
Summed jacks for routing control voltage and modulation signals into the oscillator.
Route oscillator signals out of the module via 3.5mm jacks, offering multiple waveforms.
Steps to connect the required power cable to the 921 module for a standard Eurorack power supply system.
Instructions for attaching the module to Eurorack rails using the included screws.
Procedure to calibrate the 921 module's octave scaling to an exact 1 V/oct. for precise control.
To Next Page