2 BASS LIMITER ENHANCER BLE400
The BATTERY COMPARTMENT is located underneath the pedal cover.
To install or replace the 9 V battery, press the hinges with a ballpen and
remove the pedal cover. Be careful not to scratch the unit.
◊ ◊
The BLE400 has no on/o switch. As soon as you insert the
jack into the in connector, the BLE400 begins running.
When not using the BLE400, remove the jack from the in
connector. This extends the life of the battery.
The SERIAL NUMBER is located at the bottom.
Safety Instructions
Do not use near water, or install near heat sources. Use only authorized
attachments/accessories. Do not service product yourself. Contact our
qualì ed servicing personnel for servicing or repairs, especially when
power supply cord or plug is damaged.
Limited Warranty
For the applicable warranty terms and conditions and additional
information regarding Music Tribe’s Limited Warranty, please see complete
details online at community.musictribe.com/pages/support#warranty.
Specications
In
Connector ¼" TS
Impedance 500 kΩ
In
Connector ¼" TS
Impedance 1 kΩ
Power Supply
9 V
𝌂
, 100 mA regulated
Behringer PSU-SB
USA/Canada 120 V~, 60 Hz
China/Korea 220 V~, 50 Hz
U.K./Australia 240 V~, 50 Hz
Europe 230 V~, 50 Hz
Japan 100 V~, 50 – 60 Hz
Power connector 2 mm DC jack, negative center
Battery 9 V type 6LR61
Power consumption 30 mA
Physical/Weight
Dimensions (H x W x D) approx. 54 x 70 x 123 mm (2.1 x 2.8 x 4.8")
Weight approx. 0.33 kg (0.7 lbs)
Behringer is constantly striving to maintain the highest professional standards. As a result of
these efforts, modifications may be made from time to time to existing products without prior
notice. Specifications and appearance may therefore differ from those listed or shown.
To Next Page
Loading...
