To Next Page

To Previous Page

5 C-1U User Manual

3. Installing the Microphone

3.1 Technical requirements

Your C-1U microphone comes with a USB connector. The audio signal is sent from the

microphone to the computer through this connection. At the same time the computer uses

the USB connection to supply the microphone with the necessary power. A connection is

made by using the included USB cable with type-B connector.

◊ Use only the included cable to ensure an optimal signal quality and a reliable

power supply.

To operate the C-1U, your computer needs to meet the following system requirements:

3.2 Initial operation

Before you can use your C-1U, connect it to a free USB port on your computer.

For initial operation of your C-1U, complete the following steps:

1) Power up your computer.

2) Connect your C-1U to a free USB port on your computer.

◊ Your operating system automatically installs the required drivers.

3) Select the C-1U as input source in your preferred audio software application.

Windows:

4) Adjust the recording level as required, using the Windows Volume Control panel.

(Shortcut: Loudspeaker icon found in the taskbar)

PC Mac

Intel or AMD CPU, 1GHz or higher G4/G5, 800 MHz or higher

minimum 512 MB RAM minimum 512 MB RAM

USB 2.0 interface USB 2.0 interface

Windows XP/Vista

Mac OS X 10.3.9 (Panther) or higher

frequency response	40 Hz to 20 kHz
max SPL	136 dB

Behringer C-1U User Manual

Other manuals for Behringer C-1U