To Next Page

To Previous Page

6 C-1U User Manual

Mac OS:

5) Adjust the recording level as required, using Audio Midi Setup in Mac OS.

◊ Your C‑1U is now ready for use.

Complete the following steps should you want to use your C-1U by default in

other applications:

Windows:

• Select the C-1U in the pull-down menu of Sound recording by clicking

on Sounds and Audio Devices in the Control Panel and then clicking the tab Audio

Mac OS:

• Select C-1U as Default Input found under the tab Audio Devices in Audio Midi Setup

of Mac OS

4. Using the Microphone

To get the sound you want, try changing the mic position relative to the sound source or

even move the microphone around in the recording room of your studio. Adjusting the

angle at which walls face the sound source can also be helpful. Only when the desired

basic sound has been achieved, should you start to use equalizers and signal processors,

if any at all (remember: less is often more!).

Due to the extremely linear frequency response and the high sonic resolution of your C-1U,

there is no need for high-frequency “EQing” that can heavily inuence the signal and

unnecessarily increase the noise level. The C-1U provides that much-desired transparency

which often gets lost during recording and mixing.

frequency response	40 Hz to 20 kHz
max SPL	136 dB

Behringer C-1U User Manual

Other manuals for Behringer C-1U