Behringer ECHO MACHINE EM600

To Next Page

ECHO MACHINE EM600

Thank you for showing your confidence in us by purchasing the BEHRINGER ECHO MACHINE

EM600. This ultimate stereo Echo Modeler delivers the whole range of analog, tape and digital delay

effects. Create any sound from vintage tape-based echo over warm analog BBD delay sound to clean

high-fidelity digital delay.

1. CONTROLS

Top view

The MIX knob is used for setting the level of the delays.

The REPEAT knob determines the number of delays.

The TIME control adjusts the delay time. The length of time depends on the selected program.

The delay time indicates how fast the signal repetitions will follow after the original signal. Low

settings allow to use the unit as a chorus or flanger. Alternatively, you can tap the tempo with

the footswitch. Turning the control overrides tap tempo settings.

With the MODE knob, you can select one of several delay modes:

The ON/BATT LED illuminates when the effect is activated. It also serves as a battery level

indicator.

Use the footswitch to activate/deactivate the effect. If you depress the pedal for more than

two seconds, you are able to enter a tempo by tapping the pedal several times in time with the

music. Depressing the pedal again for more than two seconds quits the tempo input mode.

The 1/4" TS connectors (IN A/IN B) connect to your instrument. Use IN A for mono applications

and both IN A and IN B if you have a stereo signal source, such as another effects unit.

The two 1/4" TS connectors OUT A and OUT B send the signals to your amp. Use both connectors if you

want to achieve a full stereo delay effect. For mono use simply plug in OUT A.

With the MOD knob, you can add a nice modulation effect to your delays (TYPE switch

position: ANALOG=Vibrato; DIGITAL=Chorus; TAPE= Wow and flutter).

The TYPE switch allows you to choose from different classic delay characteristics, ranging

from TAPE (delays with subtle high-frequency damping), DIGI (high-quality delays) to ANALOG

(dark and slightly distorted delays).

With the TRAILS switch, you can prevent delays from being cropped when bypassing the

effect.

Use the DC IN connection at the front of the unit to plug in a 9 V power supply (not included).

The BATTERY COMPARTMENT is located underneath the pedal cover. To install or replace the 9 V

battery (not included), press the hinges with a ballpoint pen and remove the pedal cover. Be careful

not to scratch the unit.

Other manuals for Behringer ECHO MACHINE EM600

User Guide2 pages

Need help?

Do you have a question about the Behringer ECHO MACHINE EM600 and is the answer not in the manual?

Summary

Behringer EM600 Controls Overview

Core Effect Parameter Controls

Adjusts delay level, repeat count, and delay time for effect shaping.

Effect Mode and Type Selection

Selects delay modes, modulation effects, and delay sound characteristics.

Operational Controls and Indicators

Includes footswitch for effect activation, status LED, and bypass behavior switch.

Input and Output Connections

Details the 1/4" TS connectors for instrument input and amplifier output.

Behringer EM600 Specifications and Safety

Technical Specifications

Provides detailed electrical and physical specifications for the EM600 unit.

General Safety Instructions

Covers essential safety precautions for operating the device, including water, heat, and servicing.

FCC Compliance Information

FCC Regulatory Statement

Details compliance with FCC rules for digital devices and potential interference mitigation.