Amplifi er Power Output
RMS power 125 Watts @ 6 Ω
Peak power 150 Watts @ 6 Ω
Speaker Size
Size 5.25″ / 133.5 mm
Audio Inputs
Channel 1: XLR / ¼” TRS Combo Jacks
Sensitivity -40 dBu to +4 dBu
Input impedance 20 kΩ / 1 MΩ switchable
Channel 2: XLR / ¼” TRS Combo Jacks
Sensitivity -40 dBu to +4 dBu
Input impedance 20 kΩ
Channel 3: RCA Jacks
Sensitivity -10 dBu to +4 dBu
Input impedance 10 kΩ
Phantom Power
Channels 2 and 3 +48 Volts, switchable
Channel Level Controls
Input Trim -∞ to + 30 dB
Max. Input Level + l +22 dBu
Link
Thru XLR connector, mic/line switchable
Main in XLR / ¼” TRS combo jack
Loudspeaker System Data
Frequency response
65 Hz to 18 kHz (-10 dB)
95 Hz to 12 kHz (-3 dB)
Sound pressure level max. 113 dB SPL @ 1 m
Limiter Optical
Dynamic equalizer Processor-controlled
Equalizer
HIGH 12 kHz / ±15 dB
MID 2 2.5 kHz / ±15 dB
LOW 100 Hz / ±15 dB
Power Supply
Voltage (Fuses)
USA/Canada 120 V~, 60 Hz (T 3.15 A H 250 V)
UK/Australia 240 V~, 50 Hz (T 3.15 A H 250 V)
Europe 230 V~, 50 Hz (T 3.15 A H 250 V)
Japan 100 V~, 50/60 Hz (T 3.15 A H 250 V)
Power consumption max. 180 Watts
Mains connection Standard IEC receptacle
Dimensions/Weight
Dimensions (H x W x D) 7.30 x 11.42 x 8.70″ / 185 x 290 x 220 mm
Weight 7 lbs / 3.20 kg
Other important information
1. Register online.
Please register your new MUSIC Tribe equipment right after you purchase it by visiting Behringer. com. Registering your purchase
using our simple online form helps us to process your repair claims more quickly and efficiently. Also, read the terms and conditions
of our warranty, if applicable.
2. Malfunction.
Should your MUSIC Tribe Authorized Reseller not be located in your vicinity, you may contact the MUSIC Tribe Authorized Fulfiller
for your country listed under “Support” Behringer. com. Should your country to be listed, please check if your problem can be dealt
with by our “Online Support” which may also be found under “Support” at Behringer. com. Alternatively, please submit an online
warranty claim at Behringer. com BEFORE returning the product.
3. Power Connections.
Before plugging the unit into a power socket, please make sure you are using the correct mains voltage for your particular model.
Faulty fuses must be replaced with fuses of the same type and rating without exception.
FEDERAL COMMUNICATIONS COMMISSION COMPLIANCE INFORMATION
To Next Page
Loading...
