Behringer Minimon MON800 - 5 Audio Connections; Connection with 1;4 or Cinch Cables; Footswitch Connection

13
MINIMON MON800
DEUTSCH
5. AUDIO CONNECTIONS
There are various ways to integrate the MON800 into your set-up. Depending on the application in
question, you will need different sets of connecting cables. The cables to use are described below.
5.1 Connection with 1/4" or cinch cables
Please use standard 1/4" or cinch cables to connect the MINIMON to other equipment. These
cables have a 1/4" or cinch connector at each end. Connect the inputs and outputs of the MON800
to the respective connectors of the other devices.
Fig. 5.1: Wiring diagram of a hi-fi cinch cable
Fig. 5.2: Unbalanced cable with 1/4" TS connectors
5.2 Footswitch connection
The MINIMON features a jack for the connection of a footswitch. Here, you can connect any
commercially available footswitch with a 1/4" TS connector. As some footswitch models on the
market have a different polarity, please be sure to use one that is appropriately wired. The correct
wiring is shown in the illustration below.
Fig. 5.3: Wiring of a 1/4" TS connector for footswitch connection
5. AUDIO CONNECTIONS