7
MINIMON MON800
DEUTSCH
2. MON800 QUICK-START SET-UP
Fig. 2.1: MON800 quick-start set-up
Please follow the instructions below to set up the MON800 as a monitor unit with different speakers
in your studio.
s Connect your computer or any other line-level source to the MIX IN A connectors on the
MON800.
s Connect your main monitor speakers to the SPEAKERS OUT A connectors, and another pair
of speakers to the B outputs.
s Press the MIX A switch in the SOURCE section.
s Use the 2-TR OUT LED display to check the signal level. If the CLIP LED lights up, please
reduce the input signal level until it settles between the -6 dB and +6 dB markings.
s The switches A and B allow you to switch the pairs of speakers on and off. Activate the A
speakers and adjust the desired volume with SPK A LEVEL.
s Switch off the A speakers and activate the B speakers. Use SPK B+C LEVEL to adjust a
volume level that is roughly the same as the A speakers volume.
s Switch between the two pairs of speakers to check the volume levels. Align the volume if
necessary.
s By switching between the two pairs of speakers you can evaluate your mixes by way of a direct
comparison using two different monitor systems.
To Next Page
Loading...
