page 4 of 6
985-40000-01200 Rev.A
2022-04-21
Condential, for internal use only. Not to be reproduced.
page 4 of 6
Synthesizers and Samplers
MONOPOLY
Calibrate BEND WHEEL minimum position
Move the BEND WHEEL to its minimum position.
Start BEND WHEEL dead zone calibration
This step is to ensure that no bend information is sent while bend wheel is not being touched.
1. Make sure the BEND WHEEL is released and returned to its center position before further operation.
2. Press button POLY UNISON, then VCO2 LED will light up.
To Next Page
Loading...
