Need help?Do you have a question about the Behringer FILTAMP MODULE 1006 and is the answer not in the manual?
General| Input Impedance | 100 kΩ |
|---|---|
| Output Impedance | 1 kΩ |
| Frequency Range | 20 Hz to 20 kHz |
| Power Supply | +12V / -12V |
| Type | Analog |
| Filter Type | Low Pass |
| Slope | 12 dB/octave |
| Controls | Resonance |
| Width | 8 HP |
Controls for filter cutoff frequency and resonance.
Controls for VCA level, gain, and response mode.
Connects external signals and control voltages to the module.
Connects the processed signal to other modules.
Steps to connect the module to a standard Eurorack power supply.
Instructions for physically installing the module into Eurorack rails.
Details on input/output types, impedance, and levels.
Details on control parameters like filter, resonance, gain, and mode.
Information on power requirements and physical dimensions.
Details on compliance with FCC rules for Class B digital devices.
Notes on modifications and user's authority to operate the equipment.
To Next Page
