(EN) Controls
FILTAMP MODULE 1006 Controls
(1) FILTER – Adjusts the cuto frequency for the lter.
(2) FILTER RESONANCE – Boosts the resonance frequencies selected
with the Filter knob, potentially causing VCF oscillation.
(3) AMPLIFIER GAIN – Controls the level of the VCA.
(4) KEYBOARD knob – Attenuate the voltage connected to the KYBD
input, which controls the cuto frequency of the lter.
(5) IN B knob – Adjusts the level of the signal connected to the
IN B input.
(6) CV 2 to VCF knob – Attenuate the voltage that is passed from the
CV 2 input to the VCF.
(7) IN A knob – Adjusts the level of the signal connected to the
IN A input.
(8) CV 1 to VCF knob – Attenuate the voltage that is passed from the
CV 1 input to the VCF.
(9) EXPONENTIAL/LINEAR switch – Select between a linear or more
natural exponential VCA response.
(10) CV 2 to VCA knob – Attenuate the voltage that is passed from the
CV 2 input to the VCA.
(11) CV 1 to VCA knob – Attenuate the voltage that is passed from the
CV 1 input to the VCA.
(12) IN A – Connect an input signal via 3.5 mm TS cable.
(13) IN B – Connect an input signal via 3.5 mm TS cable.
(14) KYBD – Connect a voltage that can be used to control the VCF
frequency.
(15) CV 1 – Connect a voltage that can be used to control the VCF
frequency or VCA level.
(16) CV 2 – Connect a voltage that can be used to control the VCF
frequency or VCA level.
(17) OUT – Send the processed signal to other modules via 3.5 mm
TS cable.
(4) (9)
(1) (2) (3)
(12) (13) (14) (15) (16) (17)
(10)
(11)
(5)
(7)
(6)
(8)
4 5Quick Start GuideFILTAMP MODULE 1006
To Next Page
Loading...
