page 4 of 5
985-40000-01175 Rev.A
2021-02-16
Condential, for internal use only. Not to be reproduced.
page 4 of 5
Synthesizers and Samplers
MONOPOLY
Turn the front panel VCO1 LEVEL to 0.
Turn the front panel VCO2 LEVEL to 0.
Repeat the above two steps until both notes are correct in the guitar tuner display. Please note that a pitch within 2 to
3 cents of the target frequency should be ne.
Repeat the above two steps until both notes are correct in the guitar tuner display. Please note that a pitch within 2 to
3 cents of the target frequency should be ne.
Turn TRANSPOSE to NORMAL, press and hold A5 key (Figure 1) and adjust the VCO1 SCALE trimmer on the bottom
panel while observing the tuner display.
Turn TRANSPOSE to NORMAL, press and hold A5 key (Figure 1) and adjust the VCO2 SCALE trimmer on the bottom
panel while observing the tuner display.
VCO2 OFFSET and SCALE Calibration
Turn the front panel VCO2 LEVEL to 10.
Turn TRANSPOSE to DOWN, press and hold A2 key (Figure 1) and adjust the VCO2 OFFSET trimmer on the bottom panel
(Figure 2) while observing the guitar tuner display.
To Next Page
Loading...
