guitar link ucg102
22
Installation for Mac
If you do not have the serial number for the installed combo, you can only run the combo +
in demo mode.
To setup the combo, proceed as follows:
Start the stand-alone application of a combo.1)
In the 2) Audio Setup window, make your choice according to the screenshot.
Please note, when using the Guitar Combos plug-in inside a host application (for example, 3)
audio recording software such as energyXT2), all the signal routing is determined in the host
application.
As of OS 10.X the stand-alone version of Guitar Combos needs an "Aggregate Device" +
for accessing inputs and outputs of the hardware. For more information on how to set
up an Aggregate Device, visit www.behringer.com.
To Next Page
Loading...
