Need help?Do you have a question about the Behringer U-CONTROL UCA222 and is the answer not in the manual?
General| Type | - |
|---|---|
| Proper use | What is the intended application of the product? |
| Sample rate | 48 kHz |
| Product color | Red |
| Frequency range | 10 - 22000 Hz |
| Audio (L/R) in | 2 |
Weight and Dimensions| Depth | 88 mm |
|---|---|
| Width | 60 mm |
| Height | 22 mm |
| Weight | 100 g |
Lists essential safety instructions for operating and maintaining the apparatus.
Guidance on initial setup, ventilation, and power supply via USB.
Instructions to register the equipment online for warranty service.
Controls headphone monitoring source (USB or input signal).
Install the device by plugging it into a free USB port; no special setup or drivers are required.
Connect the UCA222 to the computer via USB; the power LED will illuminate.
Connect the audio source to the INPUT stereo RCA jacks for recording.
Plug headphones into the PHONES jack and adjust volume.
Send stereo signal in digital audio format (S/PDIF) via OPTICAL OUTPUT.
Guides studio recording using a mixer to capture overall mix and multiple sources.
Connect powered monitor speakers to the UCA222 OUTPUT RCA jacks.
Monitor input signal with headphones, adjusting volume via the adjacent control.
Connect guitar to V-AMP 3 instrument input using a standard 1/4" cable.
Connect V-AMP 3 outputs to UCA222 RCA inputs, possibly requiring adapters.
Set the recording program to record input from the UCA222.
To Next Page
