guitar link ucg102
20
Installation for Mac
Installation for Mac3.
Installing the UCG1023.1
To setup the UCG102, proceed as follows:
Power on your computer.1)
Connect the UCG102 with the USB cable to your Mac.2)
Installing the Guitar Combos software3.2
The Guitar Combos software consists of three different combos. Choose any or all of them for instal-
lation. With the serial number on the CD sleeve you can fully activate one combo. The other combos
can be run in demo mode with the following restrictions:
Saving of sounds is disabled =
Quits after 30 minutes =
Total recall is disabled =
To install a combo on your system, proceed as follows:
From the folder "NI Guitar Combos" on your CD, choose the combo you wish to install and open 1)
the respective archive le (ZIP) by double-clicking on its entry.
Double-click on the installer icon on the desktop, to start the installation.2)
Follow the on-screen instructions.3)
To Next Page
Loading...
