5
ULTRA-G GI100
+ Before using the PAD switches, be sure that the ULTRA-G is clip-
ping, and not the mic preamp on the console. You should only
attenuate the input signal via the GI100s PAD switches if its CLIP
LED lights up frequently or remains lit. If this is not the case and
distortion occurs, check the console settings. It is always best to
avoid attenuation of the DI input to ensure an optimal signal-to-
noise ratio.
7
INPUT. Use this 1/4" mono jack to connect the signal source, e.g. your
guitar, with a high-quality standard instrument cable.
+ The GI100 is switched on as soon as you insert a plug into the
INPUT. The battery is disconnected when the plug is removed.
For this reason, the GI100 has no on/off switch. To preserve
battery life, always disconnect the input when the ULTRA-G is not
in use.
8
The DIRECT LINK TO CABINET is a direct output of the input signal,
allowing you for example to simultaneously run your instrument through
the GI100 and complete your normal signal path by connecting the
DIRECT LINK to an amp or speaker cabinet.
+ The INPUT and DIRECT LINK sockets are directly connected. When
connecting the speaker output of a tube amp to the input of the
GI100, please be sure to connect a guitar speaker or other appro-
priate impedance load to the DIRECT LINK socket in order to
avoid possible damage to your amplifier.
1. CONTROLS
To Next Page
Loading...
