Need help?Do you have a question about the Beijer Electronics QTERM-G55 and is the answer not in the manual?
General| Resolution | 640 x 480 pixels |
|---|---|
| Operating System | Linux |
| Power Supply | 24 VDC |
| Enclosure | Plastic |
| Protection Rating | IP65 |
| Display Size | 5.7 inches |
| Communication Interfaces | Ethernet, USB, RS-232 |
| Operating Temperature | -20 to +60 °C |
Steps for powering on the QTERM-G70 terminal for the first time and initial application loading.
Instructions for navigating Power On Setup using the terminal's touch screen interface.
Instructions for navigating Power On Setup using the terminal's keypad interface.
Instructions for navigating Power On Setup using an external keyboard.
Description of available functions within the Power On Setup utility by category.
Configuring flash memory modes (Download, Develop, Run App, Run Default) in Power On Setup.
Adjusting display contrast, backlight, orientation, touch, and DCache in Power On Setup.
Calibrating terminal temperature and date/time settings via Power On Setup.
Setting up Ethernet network parameters like DHCP, IP address, subnet mask, and gateway.
Configuring wireless Ethernet settings: SSID, Net Type, Channel, and Region.
Configuring wireless security: authentication, encryption, and WPA/WEP keys.
Configuring serial port settings: Baud Rate, Data Bits, Parity, Stop bits, Flow Control, TX Timeout, Protocol.
Configuring keypad features: Keyclick, Key Repeat, Rpt Delay, Rpt Rate, AutoShift, AutoPower, Backlight.
Configuring keyboard repeat delay time and rate for connected keyboards.
Step-by-step guide to calibrate the terminal's touch screen.
To Next Page
