Beka Hospitec AVERO Motion - Page 44

Appendix
Operating manual AVERO Motion V2.6 E Page 44 of 48
Recommended distance between portable and mobile communications equipment and
the AVERO Motion (Table 206)
The AVERO Motion is intended for use in an electromagnetic environment with controlled HF
interferences. The customer or the user of the AVERO Motion can avoid electromagnetic
interference by respecting and observing the minimum distance between portable and mobile
HF telecommunication devices (transmitters) and the AVERO Motion depending on the rated
output of the communication device as given below.
Rated output
of the transmitter
W
Separation distance depending on the transmitting frequency
in m
150 kHz to 800 MHz
d=0.35√P
80 MHz to 800 MHz
d=1.2√P
800 MHz to
2.5 GHz
d=2.3√P
0.01
0.1
1
10
100
0.04
0.11
0.35
1.1
3.5
0.12
0.38
1.2
3.8
12
0.23
0.73
2.3
7.3
23
For transmitters rated at a maximum output power not listed above, the recommended
separation distance d in meters (m) can be determined using the equation applicable to the
frequency of the transmitter, where P is the maximum output power rating of the transmitter in
watts (W) according to the specifications given by the transmitter manufacturer.
NOTE 1: At 80 MHz and 800 MHz, the separation distance for the higher frequency range
applies.
NOTE 2: These guidelines could not apply to all situations. Electromagnetic propagation
is affected by absorption and reflection from structures,
objects and people.