What to do if my Beko CFB 6432 XG does not work?
If your Beko Ventilation Hood isn't working, there are a few things to check: * First, examine your fuse to ensure it's functioning correctly. Your fuse might be closed, make it work. * Next, verify the electrical connection, making sure the mains voltage is between 220-240V. * Finally, check if other kitchen appliances are working to rule out a broader electrical issue.
Why is the air intake of my Beko Ventilation Hood poor?
Poor air intake in your Beko Ventilation Hood can stem from a few causes: * The aluminum filter may need cleaning. Under normal conditions, it should be cleaned at least once a month. * The air vent flue might not be in the correct position. Ensure it is in the ''on'' position. * If your unit uses a carbon filter, it may need replacing. These filters should typically be changed every 3 months.
How to fix the lighting lamp if it does not work in my Beko CFB 6432 XG Ventilation Hood?
If the lighting lamp in your Beko Ventilation Hood isn't working, consider the following: * Check the electrical connection to ensure the mains voltage is between 220-240V. * Verify that the lamp switch is in the “on” position. * Ensure that the lamps themselves are not faulty and need replacement.
Manufacturer is not liable for damages resulting from incorrect or improper installation.
The extractor hood is designed exclusively for domestic use to eliminate kitchen smells.
Switch off or unplug the appliance from the mains supply before carrying out maintenance.
This product complies with EU WEEE Directive and bears a classification symbol for waste electrical and electronic equipment.
Package of the product is made of recyclable materials in accordance with national legislation.
This canopy hood is designed to be fixed to any rigid vertical surface, over a gas or electric hotplate.
Safety warnings related to installation and use of the cooker hood.
General instructions and steps for installing the hood.
Step-by-step guide on how to open and remove the metal grille panel.
Instructions for fixing the hood to a wall cabinet, with or without predrilled holes.
Guidelines for mounting the hood directly onto a wall, including drilling and screw usage.
Explains how to set up the hood for evacuation or internal recirculation mode.
Details the electrical connection process and how to perform a working test.
Controls are located on the right hand side for illumination and speed selection.
Regular maintenance and cleaning ensure good performance and reliability.
General| Type | Built-under |
|---|---|
| Control type | Buttons |
| Product color | Stainless steel |
| Built-in display | No |
| Intensive speed | - |
| Number of speeds | 3 |
| Type of extraction | Ducted/Recirculating |
| Noise level (low speed) | 54 dB |
| Maximum extraction power | 240 m³/h |
| Noise level (high speed) | 66 dB |
| Noise level (medium speed) | 60 dB |
| Number of filters | 1 pc(s) |
| Grease filter type | Metal |
| Bulb power | 28 W |
| Number of bulbs | 1 bulb(s) |
| Filter | Carbon, Synthetic |
Weight and Dimensions| Depth | 490 mm |
|---|---|
| Width | 598 mm |
| Height | 150 mm |
| Weight | 8490 g |
To Next Page
