Beko DIN48430 - Cleaning the Impellers; Lower Impeller Assembly; Upper Impeller

Dishwasher / User’s Manual
41 / 47
EN
Maintenance and cleaning
Upper mpeller
Check if the holes on the upper impeller (1)
are clogged. If they are clogged, remove
and clean the impeller. Turn its nut to left to
remove the upper impeller.
Make sure that the nut is tightened well
when installing the upper impeller.
Cleanng the mpellers
Clean the impellers for the machine to work
efficiently.
A
Do not try to rotate the impeller
by holding its ends. Trying to
rotate the end sections may
cause the gear system within
the impeller to break.
Lower mpeller assembly
C
If the washing performance
decreases, check if the holes
on the lower impeller assembly
are clogged. If they are clogged,
remove and clean the impeller
assembly.
C
To remove and clean the lower impeller
assembly together, hold by one hand from
the (C) points shown in the figure and pull
up to remove. After cleaning, follow these
steps in reverse order to reinstall the
impeller assembly.