What to do if my Beko Washer is leaking water from the bottom?
If you notice water leaking from the bottom of your Beko washer, it's likely due to issues with the hoses or the pump filter. Make sure the seals of the water inlet hoses are securely fitted. Also, ensure that the pump filter is completely closed.
Why is my Beko WMI 71441 not filling with water?
If your Beko washer isn't filling with water, check the following: * Ensure the water tap is fully open. * Make sure the water inlet hose isn't bent; flatten it if it is. * Clean the water inlet filter if it's clogged. * Ensure the loading door is completely closed.
What to do if my Beko WMI 71441 loading door won't open?
If the loading door of your Beko washer won't open, it could be due to a few reasons: * The door lock might be activated because of the water level; drain the water by running the Pump or Spin programme. * The machine might be heating water or in the spinning cycle; wait until the programme completes. * The child lock might be engaged; wait a couple of minutes for deactivation.
Why does my Beko WMI 71441 not switch to the spinning step?
Your Beko washer may not switch to the spinning step if there is an imbalance of laundry in the machine. The automatic unbalanced load detection system might be activated due to the laundry's distribution in the drum. Also, the machine won't spin if water is not drained completely, so check the filter and the draining hose. Excessive foam might also prevent spinning, so use the recommended amount of detergent.
How to fix a Beko WMI 71441 Washer that won't start or select a programme?
If your Beko washer won't start or select a programme, it may have switched to self-protection mode due to a supply problem (line voltage, water pressure, etc.). To reset the machine to factory settings, press and hold the Start / Pause / Cancel button for 3 seconds.
Why is my Beko WMI 71441 Washer directly discharging the water it takes in?
If your Beko washer is immediately discharging the water it takes in, the draining hose might not be at the correct height. Connect the water draining hose as described in the operation manual.
Why doesn't my Beko WMI 71441 work and nothing is displayed on the screen?
If your Beko washer doesn't work and nothing is displayed on the screen, check if the plug is properly plugged into the mains outlet, inspect the fuse, ensure there's no power outage, and verify that the “On/Off” button has been pressed.
Why does my Beko WMI 71441 take longer than the manual specifies?
The washing cycle on your Beko washer might be taking longer than usual due to several reasons: * Low water pressure: The machine waits to take in enough water. * Low voltage: Washing time is extended to compensate. * Low input water temperature: Heating the water takes longer. * Increased rinses: The machine may increase rinse water or add an extra rinse. * Excessive foam: The automatic foam absorption system may be activated due to too much detergent. Use the recommended amount of detergent.
Why does my Beko Washer programme time not countdown?
If the programme time on your Beko washer isn't counting down, the timer may stop during water intake until the machine takes in enough water. It might also stop during the heating step until the machine reaches the selected temperature, or during the spinning step, if the laundry is unbalanced.
Why did my Beko WMI 71441 stop shortly after starting a programme?
If your Beko washer stopped temporarily shortly after the programme started, it might be due to low voltage. The machine will resume running when the voltage returns to normal.
To Next Page
General
