Why is my laundry still wet after the programme ends on my Beko WMI 71441?
If your laundry is still wet after the programme ends on your Beko washer, it's possible that excessive foam occurred, activating the automatic foam absorption system due to too much detergent usage. Use the recommended amount of detergent.
Why is my Beko WMI 71441 not filling with water?
If your Beko washer isn't filling with water, check the following: * Ensure the water tap is fully open. * Make sure the water inlet hose isn't bent; flatten it if it is. * Clean the water inlet filter if it's clogged. * Ensure the loading door is completely closed.
What to do if my Beko WMI 71441 loading door won't open?
If the loading door of your Beko washer won't open, it could be due to a few reasons: * The door lock might be activated because of the water level; drain the water by running the Pump or Spin programme. * The machine might be heating water or in the spinning cycle; wait until the programme completes. * The child lock might be engaged; wait a couple of minutes for deactivation.
Why does my Beko WMI 71441 not switch to the spinning step?
Your Beko washer may not switch to the spinning step if there is an imbalance of laundry in the machine. The automatic unbalanced load detection system might be activated due to the laundry's distribution in the drum. Also, the machine won't spin if water is not drained completely, so check the filter and the draining hose. Excessive foam might also prevent spinning, so use the recommended amount of detergent.
How to fix a Beko WMI 71441 Washer that won't start or select a programme?
If your Beko washer won't start or select a programme, it may have switched to self-protection mode due to a supply problem (line voltage, water pressure, etc.). To reset the machine to factory settings, press and hold the Start / Pause / Cancel button for 3 seconds.
Why is foam overflowing from the detergent drawer of my Beko Washer?
If foam is overflowing from the detergent drawer of your Beko washer, it's likely because too much detergent was used. Mix 1 tablespoonful of softener with ½ liter of water and pour it into the main wash compartment of the detergent drawer.
Why is there detergent left on my laundry after washing in my Beko Washer?
If there's detergent left on your laundry after washing in your Beko washer, it could be because: * The machine was overloaded. * The wrong programme and temperature were selected. * The wrong detergent was used. Avoid overloading, select the correct settings, and use the appropriate detergent. Clean the drum regularly.
Why is there too much foam forming in my Beko WMI 71441?
If too much foam is forming in your Beko washer, it could be due to: * Using improper detergents. * Using too much detergent. * Improper detergent storage. * Washing meshed laundry. * Putting detergent in the wrong compartment. Use appropriate detergents, use only sufficient detergent, store detergent properly, and put it in the correct compartment.
Why do stains persist on my laundry after washing in my Beko WMI 71441 Washer?
If stains persist or your laundry isn't whitened after washing in your Beko washer, it could be due to: * Using too little detergent. * Overloading the machine. * Selecting the wrong programme and temperature. * Using the wrong type of detergent. * Putting detergent in the wrong compartment. Use the recommended amount of detergent, avoid overloading, select the correct settings, and use the appropriate detergent. Clean the drum regularly.
Why did my Beko WMI 71441 stop shortly after starting a programme?
If your Beko washer stopped temporarily shortly after the programme started, it might be due to low voltage. The machine will resume running when the voltage returns to normal.
To Next Page
General
